日本天天爽_99TV香蕉视频在线_中文一区_欧洲mv亚洲mv永久入口导航_天天看大片WWWWWWWW_7799精品視頻免費觀看网站_九色蝌蚪论坛国产_夜夜草视平_久久AV红桃秘 一区二区

操作過程：
    1、插上電源，打開電源總開關，電源指示燈隨即著亮；（注意：整機必須有合適牢靠的保護地線）；將恒溫器調較至所需溫度（通常為130℃-200℃，如AAA級環保料燙膜溫度一般為130℃-160℃）；將定時器調較至所需時間（通常為5至20秒左右）；
    2、當發熱板溫度上溫到指定溫度時先在發熱板平鋪3到5層熱熔膜（按膜的厚度而定），注意鋪平最好不要有氣泡；
    3、將繡好的繡品有膜的一邊平鋪發熱板上，注意鋪平；
    4、手動壓下壓力手柄，等到時間倒數到“0”時拉上壓力手柄；
    5、取下繡品即可（如果還有部分燙剝不干凈可重復第3第4步）。

Operation process:
    1. Plug in the power supply, turn on the main power switch, and the power indicator light will be on; (Note: the whole machine must have a suitable protective ground wire); adjust the thermostat to the required temperature (usually 130 °C-200 °C) For example, the AAA grade environmentally friendly material film temperature is generally 130 ° C -160 ° C); adjust the timer to the required time (usually about 5 to 20 seconds);
    2. When the temperature of the heating plate reaches the specified temperature, firstly spread 3 to 5 layers of hot melt film on the heating plate (depending on the thickness of the film), it is best not to have bubbles when laying the flat;
    3, the embroidered embroidery has a film on one side of the flat heating plate, pay attention to flatten;
    4. Manually press down the pressure handle and wait until the time counts down to “0” to pull the pressure handle;
    5, remove the embroidery (if there is still some hot peeling is not clean can repeat the third step 4).